Our BLE Update utility available on our as part of the latest BLE SDK installer. When you install the SDK, the BLE Update utility will be installed as well unless you specifically un-check that option. FOR WINDOWS XP USERS: there is s special version of BLE Update (v1.0.6) which is required if you are using Windows XP due to WMI compatibility issues. The latest version of this application will not work properly on Windows XP, and you will need to download v1.0.6 from the ' PC Tools' section of the BLE downloads page and install it separately. The BLE Update tool allows you to enter license information for the module if it is not already present, and upon reprogramming the module it also maintains the MAC address, license key, and other minor hardware configuration.
The SmartRF Flash Programmer tool provided by Texas Instruments does not do this, and so should be avoided as it will always wipe out the license key. Before working through the steps outlined below, you should make sure that you have your CC debugger connected to the module or development kit board as required, and that the debugger LED is GREEN. If you are having trouble getting to this step, start with the following troubleshooting guide: • Once you have a green LED, continue on with this guide. Download and install the latest BLE SDK The BLE Update utility uses tools that are part of our BLE SDK.
BlueSee BLE Debugger Mac版是Mac平台上的一款蓝牙信号搜索工具，BlueSee BLE Debugger Mac版能够探索您周围的蓝牙信号的环境，能够帮助用户发现当前系统所支持的外围设备。. The BLE Update utility uses tools that are part of our BLE SDK. In order to use it, you will first need to download and install the latest available SDK for our BLE products. This archive can be found on the BLE SDK Downloads page, listed under the ' Software Releases ' section. Download and install ElEGOO BLE Bluetooth Tool for PC and you can install ElEGOO BLE Bluetooth Tool 1.1.1 in your Windows PC and Mac OS. ElEGOO BLE Bluetooth Tool is.
Security spy software for mac. In order to use it, you will first need to download and install the latest available SDK for our BLE products. This archive can be found on the, listed under the ' Software Releases' section. This installer is approximately 20 MB. If you don't already have this installed, download it and install it now.
Open BLE Update and verify that the CC debugger appears correctly You may need to click the 'Refresh' button in order for the CC debugger to show up in the list. If the debugger is connected and has a green LED but still does not show up in this list, it may be missing a driver. Check in Device Manager to see if any devices have problems or are missing drivers; if so, you should download one of the following from Texas Instruments: • (ZIP, 2017 KB) • (product page) • (product page) The first one is all you really need, but the other two may provide helpful tools for other development and both of them also install the required USB driver during their normal setup process.
Get the BLE11x module info to verify connectivity and license info This step is optional, but it's good to do it at least once to make sure everything looks correct. If the Address value shows 'ff:ff:ff:ff:ff:ff', that means either the device is not connected properly (in which case the Serial number will also be all zeros), or the MAC address has been overwritten, typically due to using the TI SmartRF Flash Programmer utility without the ' Retain IEEE address during programming' option enabled during flashing. If your MAC address has been overwritten, you may contact us for a replacement address.
Applying a new MAC address requires the use of the TI SmartRF Flash Programmer utility. You may also have a missing license key, and a 'Request license key' link shown instead. License keys are free for all of our customers, and modules manufactured after October 2012 include license keys pre-programmed from the factory. Once you are satisfied with the displayed results from the Info request, continue to the next step.